联系我们

地址:安徽省合肥市蜀山区
QQ:1185058891
手机:18119695096
行业新闻

激光未完全切割透状态的分析 切割低碳钢时出现非正常火花的解决方法

激光不完全切割状态分析。通过分析可以发现在一些情况下,以下是主要加工不稳定:在激光头喷嘴加工选择不匹配厚度;激光切削线速度,减少需要控制线速度;此外,还需要特别注意激光透镜5mm以上l3030切削碳钢激光切割机时,需要改变“焦距7.5。

激光未完全切割透状态的分析 切割低碳钢时出现非正常火花的解决方法

低碳钢切割时异常火花的解决方法。这种情况会影响切割面的切削质量。在这个时候,在其他参数都正常,应考虑以下几点:激光头喷嘴喷嘴损失,应及时更换喷嘴。在不更换新喷嘴的情况下,应增加气体压力,使喷嘴与激光头之间的连接松。此时应立即停止切割,检查激光头连接状态,重新线程。


Analysis of the state of laser incomplete cutting. The analysis can be found in several cases the following is main machining instability: selection and processing in laser head nozzle does not match the thickness; laser cutting line speed, reduce the need to control the line speed; in addition, also need to pay special attention to the laser lens above 5mm in carbon steel cutting L3030 laser cutting machine when the need to change the focal length of 7.5 ".


Solution of abnormal spark when cutting low carbon steel. This condition will affect the cutting quality of the cutting surface. At this time in other parameters are normal, should consider the following: laser head nozzle NOZZEL loss, should be timely replacement nozzle. In the case of no replacement of the new nozzle, the gas pressure should be increased, and the connection between the nozzle and the laser head is loose. At this time should immediately suspend the cutting, check the laser head connection state, re thread.


合肥钣金加工官方网站:http://www.hfzbjg.com/

最新内容:



上一篇: 合肥钣金切割加工小孔(直径小与板厚)变形情况的分析
下一篇: 合肥钣金加工浅谈激光切割加工时穿刺点的选择

    版权所有:合肥机械设备有限公司合肥网络工程 合肥墙绘 QQ:1185058891 手机:18119695096 邮箱:18119695096@qq.com地址:合肥市桃花工业园拓展区汤口路与万佛山路交口

关键词:合肥激光切割加工  合肥激光切割钣金加工  合肥钣金加工  合肥碳钢板加工  合肥不锈钢切割  合肥钢板切割  合肥碳钢板切割  合肥大型激光切割加工